[Apr 04, 2024] 100% Real & Accurate NSE7_EFW-7.0 Questions with Free and Fast Updates
Self-Study Guide for Becoming an Fortinet NSE 7 - Enterprise Firewall 7.0 Expert
NEW QUESTION # 55
View these partial outputs from two routing debug commands:
Which outbound interface will FortiGate use to route web traffic from internal users to the Internet?
- A. port1
- B. port2
- C. Both port1 and port2
- D. port3
Answer: A
NEW QUESTION # 56
View the exhibit, which contains the output of a BGP debug command, and then answer the question below.
Which of the following statements about the exhibit are true? (Choose two.)
- A. The local BGP peer has received a total of three BGP prefixes.
- B. For the peer 10.125.0.60, the BGP state of is Established.
- C. Since the BGP counters were last reset, the BGP peer 10.200.3.1 has never been down.
- D. The local BGP peer has not established a TCP session to the BGP peer 10.200.3.1.
Answer: B,D
NEW QUESTION # 57
View the exhibit, which contains the output of a BGP debug command, and then answer the question below.
Which of the following statements about the exhibit are true? (Choose two.)
- A. The local BGP peer has received a total of three BGP prefixes.
- B. For the peer 10.125.0.60, the BGP state of is Established.
- C. Since the BGP counters were last reset, the BGP peer 10.200.3.1 has never been down.
- D. The local BGP peer has not established a TCP session to the BGP peer 10.200.3.1.
Answer: B,D
NEW QUESTION # 58
Refer to the exhibit, which shows the output of a diagnose command.
What can be concluded about the debug output in this scenario?
- A. FortiGate used 64.26.151.37 as the initial server to validate its contract.
- B. There is a natural correlation between the value in the Packets field and the value in the Weight field.
- C. Servers with a negative TZ value are less preferred for rating requests.
- D. The first server provided to FortiGate when it performed a DNS query looking for a list of rating servers, was 121.111.236.179.
Answer: B
NEW QUESTION # 59
Examine the partial output from the IKE real time debug shown in the exhibit; then answer the question below.
Why didn't the tunnel come up?
- A. One IPsec gateway is using main mode, while the other IPsec gateway is using aggressive mode.
- B. IKE mode configuration is not enabled in the remote IPsec gateway.
- C. The remote gateway's Phase-1 configuration does not match the local gateway's phase-1 configuration.
- D. The remote gateway's Phase-2 configuration does not match the local gateway's phase-2 configuration.
Answer: C
NEW QUESTION # 60
Which two configuration settings change the behavior for content-inspected traffic while FortiGate is in conserve mode? (Choose two.)
- A. IPS failopen
- B. mem failopen
- C. UTM failopen
- D. AV failopen
Answer: A,D
NEW QUESTION # 61
Examine the output of the 'get router info bgp summary' command shown in the exhibit; then answer the question below.
Which statement can explain why the state of the remote BGP peer 10.200.3.1 is Connect?
- A. The local peer is receiving the BGP keepalives from the remote peer but it has not received any BGP prefix yet.
- B. The local peer is receiving the BGP keepalives from the remote peer but it has not received the OpenConfirm yet.
- C. The TCP session for the BGP connection to 10.200.3.1 is down.
- D. The local peer has received the BGP prefixed from the remote peer.
Answer: C
NEW QUESTION # 62
View the exhibit, which contains the output of a diagnose command, and then answer the question below.
Which statements are true regarding the output in the exhibit? (Choose two.)
- A. FortiGate used 209.222.147.3 as the initial server to validate its contract.
- B. FortiGate will probe 121.111.236.179 every fifteen minutes for a response.
- C. Servers with the D flag are considered to be down.
- D. Servers with a negative TZ value are experiencing a service outage.
Answer: A,B
NEW QUESTION # 63
Which of the following statements is true regarding a FortiGate configured as an explicit web proxy?
- A. FortiGate limits the number of simultaneous sessions per explicit web proxy user. This limit CANNOT be modified by the administrator.
- B. FortiGate limits the number of workstations that authenticate using the same web proxy user credentials. This limit CANNOT be modified by the administrator.
- C. FortiGate limits the total number of simultaneous explicit web proxy users.
- D. FortiGate limits the number of simultaneous sessions per explicit web proxy user The limit CAN be modified by the administrator
Answer: C
NEW QUESTION # 64
Which two statements about FortiManager is true when it is deployed as a local FDS? (Choose two.)
- A. It caches available firmware updates for unmanaged devices.
- B. It supports rating requests from both managed and unmanaged devices.
- C. It provides VM license validation services.
- D. It can be configured as an update server, or a rating server, but not both.
Answer: B,C
NEW QUESTION # 65
View the exhibit, which contains the output of diagnose sys session stat, and then answer the question below.
Which statements are correct regarding the output shown? (Choose two.)
- A. All the sessions in the session table are TCP sessions.
- B. There are 0 ephemeral sessions.
- C. There are 166 TCP sessions waiting to complete the three-way handshake.
- D. No sessions have been deleted because of memory pages exhaustion.
Answer: B,D
NEW QUESTION # 66
Which of the following conditions must be met for a static route to be active in the routing table? (Choose three.)
- A. The next-hop IP address is up.
- B. There is no other route, to the same destination, with a higher distance.
- C. The outgoing interface is up.
- D. The next-hop IP address belongs to one of the outgoing interface subnets.
- E. The link health monitor (if configured) is up.
Answer: C,D,E
NEW QUESTION # 67
Which two statements about conserve mode are true? (Choose two.)
- A. FortiGate exits conserve mode when the system memory goes below the configured green threshold.
- B. FortiGate starts dropping all new sessions when the system memory reaches the configured red threshold.
- C. FortiGate starts taking the configured action for new sessions requiring content inspection when the system memory reaches the configured red threshold.
- D. FortiGate enters conserve mode when the system memory reaches the configured extreme threshold.
Answer: A,C
NEW QUESTION # 68
View the exhibit, which contains the partial output of a diagnose command, and then answer the question below.
Based on the output, which of the following statements is correct?
- A. Remote gateway IP is 10.200.5.1.
- B. Quick mode selectors are disabled.
- C. DPD is disabled.
- D. Anti-reply is enabled.
Answer: D
NEW QUESTION # 69
Which configuration can be used to reduce the number of BGP sessions in an IBGP network?
- A. Neighbor range
- B. Route reflector
- C. Next-hop-self
- D. Neighbor group
Answer: B
Explanation:
Route reflectors help to reduce the number of IBGP sessions inside an AS. A route reflector forwards the routers learned from one peer to the other peers. If you configure route reflectors, you dont' need to create a full mesh IBGP network. All clients in a cluster only talck to route reflector to get sync routing updates. Route reflectors pass the routing updates to other route reflectors and border routers within the AS.
NEW QUESTION # 70
View the exhibit, which contains the output of a BGP debug command, and then answer the question below.
Which of the following statements about the exhibit are true? (Choose two.)
- A. Since the counters were last reset; the 10.200.3.1 peer has never been down.
- B. The local router's BGP state is Established with the 10.125.0.60 peer.
- C. The local router has not established a TCP session with 100.64.3.1.
- D. The local router has received a total of three BGP prefixes from all peers.
Answer: B,C
NEW QUESTION # 71
Examine the output of the 'get router info ospf interface' command shown in the exhibit; then answer the question below.
Which statements are true regarding the above output? (Choose two.)
- A. Two OSPF routers are down in the port4 network.
- B. The local FortiGate has been elected as the OSPF backup designated router.
- C. There are at least 5 OSPF routers connected to the port4 network.
- D. The port4 interface is connected to the OSPF backbone area.
Answer: C,D
NEW QUESTION # 72
Refer to the exhibit, which contains the partial output of the get vpn ipsec tunnel details command.
Based on the output, which two statements are correct? (Choose two.)
- A. Phase 2 authentication is set to sha1 on both sides.
- B. Anti-replay is disabled.
- C. Hub2Spoke1 is configured on interface wan2.
- D. Hub2Spoke1 is a policy-based VPN.
Answer: A,C
NEW QUESTION # 73
......
NSE7_EFW-7.0 Study Guide Realistic Verified NSE7_EFW-7.0 Dumps: https://examcollection.guidetorrent.com/NSE7_EFW-7.0-dumps-questions.html